Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Before
After
Before
After
Before
AfterGarage Door Before & After in Los Angeles, CA
Photos matter more than promises. That’s why every Servo job since 2015 closes with a documented photo record: the failed part as we found it, the new component installed, and the finished door in motion. These before-and-after write-ups show the same evidence our customers receive after every visit, no filters, no stock imagery, just what the technician saw through the lens.
Recent Transformations
Torsion Spring Replacement in Silver Lake
The torsion spring measured 0.243-inch wire diameter and had snapped cleanly at the center coil, leaving the door dead on the tracks. We replaced both springs as a matched pair, lubed the bearing plates, and rebalanced the drum tension. The door now lifts with two fingers and stops level at the halfway point, exactly as it should. Total on-site time: two hours, including the documented photo record the customer took home.
Panel Replacement After a Delivery Truck Strike in Atwater Village
A delivery truck clipped the bottom panel and pushed it three inches into the track plane. The panel was beyond straightening; the stiles had split where the hinges mounted. We pulled the track back to plumb, swapped the damaged panel for a factory color-matched replacement, and reset the weather seal. You’d never know the door took a hit, and the owner kept the old panel to show the building manager.
Opener Logic Board Failure in Sherman Oaks
The opener would run for two seconds and stop, and the wall console blinked a code matching a logic board fault. We bench-tested the board and found a burned capacitor; the motor and carriage were fine. Rather than quote a full opener, we replaced the board, reprogrammed the limits and remotes, and ran a full cycle test. The customer saved roughly $230 against a new unit and got the same one-year parts warranty.
Cable Off the Drum on a Steep Grade in Mount Washington
Grade matters on Mount Washington. The door sat slightly out of level, and over years the left cable walked off the drum and frayed at the loop. We leveled the track, installed new 7-foot cables on both sides, and reset the spring tension to compensate for the slope. The door now tracks without pulling to one side, and the owner said it’s the quietest the door has run since they bought the place.
Full Door Replacement on a 1920s Spanish Revival in Echo Park
The original tilt-up door from the 1920s had sagged corners and a tongue-and-groove panel that had rotted from sprinkler overspray. We measured for a custom sectional to fit the odd opening height, matched the stucco lines with a Clopay smooth-face door, and added a side-mount opener to preserve the open ceiling. The new door raises and lowers without a sound, and the photo record shows the original iron hinges we preserved for the homeowner.
Emergency Roller and Hinge Failure in West Adams
Saturday night, door half-open, one roller shattered and the panel cocked sideways. The homeowner called at 9:40 pm; our technician arrived at 10:15 pm with the parts on the truck. We replaced all ten rollers with 11-ball nylon-bearing units, rehung the panel, and adjusted the track spacing. Door was back in service by 11 pm, and the customer had the photo record on their phone before we left the driveway.
Want Results Like These?
Every job above started with a written price before any work began, and every one ended with a documented photo record in the customer’s hands. That’s Clause 1 and Clause 4 of The Haven Standard, applied to every door we touch in Los Angeles. Call (213) 348-6550 for a flat upfront quote. If another company already gave you a written estimate, bring it and get a free second opinion.
Written by Marcus Deller, Owner at Servo Garage Doors Los Angeles, serving Los Angeles since 2015.